Insulated piercing connector

Simple installation

There is no need to adjust the pre-positioned shearhead bolts prior to assembly.
If required,strip the conductor to the length specified on the connector.
Begin the assembly with the dead conductor.
Insert each conductor fully along the axis of the connector.Hold the conductor in place whilst pre-tightening the shearhead bolts to locate the cable.

For installation under load(max.90A)( “RED”side only)

Secure the connector with the 1st conductor installed,to the ABC bundle with tape or a cable tie.
Secure the elctrical contact between the stripped conductor and the end of the adaptor during the tightening.
To complete the installation,tighten the shearhead bolt untill breaks off.

II-DISMANTLIIMG "REDH" SIDE ONLY

The connector can be removed,off load,for red side by use 2nd remaining hex head.
To remove under load,cut the conductro approx.1 cm from the connector,using an appropriate cable cutter.then lose the “red” screw and remove the remaining section.
Use the plug provided to reseal the connector.

Ill-REINSTALLATION ,,REDM SIDE ONLY

Strip the conductor to the length specified on the connector.
Insert the stripped end of the conductor into the connector,as instructed in section 1.
To complete the installation,tighten the hex head bolt to the torque level specified on the connector.

IV-CAUTIOI\J(SM35-P35)

Care should be taken to ensure that the correctly prepared conductor is inserted into the correct end of the connector. 
“RED” load making sied for tripped conductor.
“LACK” insulation piercing for un-stripped conductor

Changan Group Co.,Ltd

Add:No.288 Wei 17th Road, Yueqing Economic Development Zone, Yueqing, Wenzhou, Zhejiang Province, P.R.China
Tel:+ 0086-577-62763666 62760888
Fax:+0086-577-62774090
Website:https://www.changanelectric.com
Email:sales@changangroup.com.cn